# Jerk-limited Type Trajectory for Multicopters
The Jerk-limited trajectory type provides smooth motion in response to user stick input or mission changes (e.g.: for filming, mapping, cargo). It generates symmetric smooth S-curves where the jerk and acceleration limits are always guaranteed.
This trajectory type is always enabled in Mission mode. To enable it in Position mode set the parameter: MPC_POS_MODE=3.
Note The jerk-limited type is used by default in position mode. It may not be suitable for vehicles/use-cases that require a faster response - e.g. racer quads.
# Trajectory Generator
The graph below shows a typical jerk-limited profile with the following constraints:
jMax
: maximum jerka0
: initial accelerationaMax
: maximum accelerationa3
: final acceleration (always 0)v0
: initial velocityvRef
: desired velocity
The constraints jMax
, aMax
are configurable by the user via parameters and can be different in manual position control and auto mode.
The resulting velocity profile is often called "S-Curve".
# Manual Mode
In manual position mode, the sticks are mapped to velocity where a full stick deflection corresponds to MPC_VEL_MANUAL.
# Constraints
XY-plane:
jMax
: MPC_JERK_MAXaMax
: MPC_ACC_HOR_MAX
Z-axis:
jMax
: MPC_JERK_MAXaMax
(upward motion): MPC_ACC_UP_MAXaMax
(downward motion): MPC_ACC_DOWN_MAX
# Auto Mode
In auto mode, the desired velocity is MPC_XY_CRUISE but this value is automatically adjusted depending on the distance to the next waypoint, the maximum possible velocity in the waypoint and the maximum desired acceleration and jerk.
# Constraints
XY-plane:
jMax
: MPC_JERK_AUTOaMax
: MPC_ACC_HOR
Z-axis:
jMax
: MPC_JERK_AUTOaMax
(upward motion): MPC_ACC_UP_MAXaMax
(downward motion): MPC_ACC_DOWN_MAX
Distance to velocity gains when close to a waypoint: