Skip to content

Holybro Pixhawk 4 Power Module (PM07)

The Power Management Board (PM Board) serves the purpose of a Power Module as well as a Power Distribution Board. In addition to providing regulated power to Pixhawk 4 and the ESCs, it sends information to the autopilot about battery’s voltage and current supplied to the flight controller and the motors.

:::note This module can be purchased as bundle with Pixhawk 4, but can also be used with other flight controllers. :::

PM07

产品规格

  • PCB Current: total 120A outputs (MAX)
  • UBEC 5v output current: 3A
  • UBEC input voltage: 2~12s LiPo
  • Dimensions: 68 x 50 x 8 mm
  • Mounting Holes: 45 x 45 mm
  • Weight: 36g

Package Contents

Package Contents

  • PM07 board
  • 80mm XT60 connector wire (installed)
  • Electrolytic capacitor: 220uF 63V (installed)
  • 2x JST GH 10P Cable
  • JST GH 8P Cable
  • 2x JST GH 6P Cable

Where to Buy

Pixhawk 4 Power Module (PM07)

Wiring/Connections

Wiring and connection information can be found in: Pixhawk 4 > Power.

Pixhawk 4 - Power Management Board

更多信息

Quick Start Guide (Holybro)