Holybro Pixhawk 4 Power Module (PM07)
The Power Management Board (PM Board) serves the purpose of a Power Module as well as a Power Distribution Board. In addition to providing regulated power to Pixhawk 4 and the ESCs, it sends information to the autopilot about battery’s voltage and current supplied to the flight controller and the motors.
:::note This module can be purchased as bundle with Pixhawk 4, but can also be used with other flight controllers. :::
Specifications
- PCB Current: total 120A outputs (MAX)
- UBEC 5v output current: 3A
- UBEC input voltage: 2~12s LiPo
- Dimensions: 68 x 50 x 8 mm
- Mounting Holes: 45 x 45 mm
- Weight: 36g
Package Contents
- PM07 board
- 80mm XT60 connector wire (installed)
- Electrolytic capacitor: 220uF 63V (installed)
- 2x JST GH 10P Cable
- JST GH 8P Cable
- 2x JST GH 6P Cable
Where to Buy
Wiring/Connections
Wiring and connection information can be found in: Pixhawk 4 > Power.
Further Information
Quick Start Guide (Holybro)